Dalam Berbagai Kondisi Kerja, Bagaimana Mengatur Parameter Ruang Sand Blast?

16 Maret 2026

Incorrect Sand Blast Rooms parameter adjustment causes poor results; this guide teaches tuning based on conditions and blast sand type.

This guide details how to adjust Sand Blast Rooms parameters under different working conditions, matching blast sand to ensure optimal blasting effect.

Learn targeted parameter adjustment methods for different Sand Blast Rooms working conditions.

How to Adjust Sand Blast Rooms Parameters for Light-Duty and Heavy-Duty Working Conditions?

Adjusting Sand Blast Rooms parameters based on light-duty and heavy-duty conditions is key to ensuring efficiency and blast sand utilization.

For light-duty conditions (e.g., small workpieces, minor rust removal), set the Ruang Ledakan Pasir pressure to 0.3-0.5MPa, select fine blast sand (0.2-0.4mm) to avoid workpiece damage. Reduce blast sand flow to 3-5kg/min, ensuring uniform blasting without waste.
For heavy-duty conditions (e.g., large workpieces, thick rust), increase Sand Blast Rooms pressure to 0.6-0.8MPa, use coarse blast sand (0.6-1.0mm) for stronger cleaning.

Boost blast sand flow to 6-8kg/min, and extend blasting time appropriately. Regardless of the condition, check blast sand quality regularly—clean, dry blast sand ensures stable Ruang Ledakan Pasir operation and consistent results.

How to Adjust Sand Blast Rooms Parameters for Different Blast Sand Types and Workpiece Materials?

Matching Sand Blast Rooms parameters to blast sand types and workpiece materials ensures ideal results and avoids damage.

For aluminum shot blast sand (soft, non-abrasive), set Sand Blast Rooms pressure to 0.4-0.6MPa, with a moderate blast sand flow of 4-6kg/min, suitable for delicate workpieces.
For steel shot blast sand (hard, wear-resistant), increase pressure to 0.5-0.7MPa, adjust blast sand flow to 5-7kg/min for heavy-duty cleaning.
Untuk benda kerja stainless steel, gunakan pasir ledakan halus dan turunkan tekanan Ruang Pasir Ledakan untuk mencegah goresan.
Untuk baja karbon, gunakan pasir ledakan kasar dan tekanan yang lebih tinggi. Secara teratur sesuaikan parameter berdasarkan aus pasir ledakan dan umpan balik benda kerja untuk menjaga Ruang Ledakan Pasir operasi secara optimal.